Aathaworld can supply and install antistatic material as well as coating to your floor, from insulating, anti static to electrostatic discharge (ESD) materials. As an anti-static floor supplier in Malaysia, we can actually offer materials that can inhibit triboelectric charging. Triboelectric charging or the triboelectric effect is dangerous, the electrified surface of any material typically exists right after two separated materials being isolated. This charging process is usually done by friction, meaning to say by rubbing one material with the other, making electrons transferred to the opponent surface. There are also another two ways to charge any single object, they are known as induction and conduction. Anti-static floor supplier Malaysia shows a few examples of daily products that work out to be charging by induction, such as wireless charging, induction cooker and lightning. Induction charging involves a process that brings any charged object close to the object that has neutral conducting, but bearing in mind that both of them are not in touch by just very near to each other. Charged object’s existence will induce or force the electrons to move around within the conductor when the placement of position is close enough. The very obvious example is the induction cooker that many households use for food cooking, wire coil’s electrical energy will be transferred through the induction process to another metal container, whereas the preliminary criteria of that vessel is the ferromagnetic.
Ferromagnetic material that is described by anti-static floor supplier in Malaysia, must have a positively huge susceptibility to any field of magnetic, at least from the external perspective. The general definition of ferromagnetism in physics is in which materials such as cobalt, iron, nickel, rare earth magnets, and metallic alloys form permanent magnets or at least attracted to other magnets. During the force of magnetization occurs, the domain within the part will then carry out its alignment to create a super field of magnetic. Cobalt is the strongest material that has the property of ferromagnetic, and has 1388 k of curie temperature. Anti-static floor supplier Malaysia says that this is where the ferromagnetic metal exhibits its ferromagnetism, and the Curie temperature will be the highest temperature representing that situation. From the perspective of physics, magnetism will be totally out of the picture when ferromagnetic material has lost the permanent magnetic field (Curie temperature is now beyond it). The next stage after the AlNiCo magnet is being heated above eight hundred and fifty celsius (Curie temperature of 850 °C) will be the paramagnetism. Magnetic properties cannot be retained when the field of magnetic is removed, is when the status of ferromagnetism is implied. Anti-static floor supplier in Malaysia says even though paramagnetism allows platinum or material like aluminium to become magnetized when exposed to the magnetic field, all these cannot be sustained when removal of the field happens.
Coils in the induction cooker will be mounted to the cooking surface’s underneath, whereas alternating current (AC) at a very high frequency will be passing through (coil’s current has created a magnetic field that is dynamic). In order to create heat that is sufficient for cooking, resistivity and permeability of cookware must be high enough as well as the classical frequency of induction cookers will be operating in between twenty-five to fifty kilohertz (kHz). This measurement unit to frequency is also known as the cycles per unit of second that can be generated, a thousand of cycles or a thousand of hertz (Hz) is equivalent to a kiloHertz (kHz). Natural electrostatic induction examples shared by anti-static floor supplier Malaysia, is the one can be found with lightning where thunder clouds hold massive numbers of charges which are positive and negative respectively at the top and bottom, the gloomy sky that looms over the ground's object, induction of positive charge will occur as an effect of electrostatic induction. While many people misunderstood that there are some things that attract lightning, in fact, nothing will attract lightning since the large scale of this natural phenomenon is impossible to be influenced by any ground’s tiny object such as metal. However, taller objects will have a higher tendency to receive a strike of lightning according to a lightning expert. To keep yourself safe theoretically, advised to get rid of outdoor, windows, doors, plumbing, faucets, baths, sinks or any electrical equipment that is corded which might put a risk for direct electricity contact, including computer and phones.
Conduction charging is when dual objects have the same charge types, in accordance with antistatic floor supplier in Malaysia. For neutral objects to have negative charge, the obtaining of electrons through a negative object must occur. There is one key distinguishing between induction and conduction, is that this type of charging will have direct contact with both objects. The examples of conduction are pretty straightforward, such as the heating up of the engine right after the car is switched on, radiator, heating pad for muscles warming, roasting over campfire and more. Antistatic floor supplier Malaysia says that heat transfer has three types which are radiation, convection and conduction. Ordinary cooking using ignited fire will involve all these and convection is the heat transfer that can occur within gases and liquids. Another example of convection will be wind occurrence, caused by the circulation of the room which is then making the warm air to another place that is cooler. Convection makes up the cause of weather, playing around with the molecules of liquid and also the air. Many of the daily activities such as ice melting, steaming cups of hot coffee to boiling of water are due to convection
Antistatic floor supplier in Malaysia is always educating the public on the dangers caused by static electricity, especially when oxygen concentration level is high or any existence of flammable gases in the room. Gases can be ignited through a mini spark and explosion is the next to damage property and humans, as well as the touching of highly electric-charged objects. Static shocks are very ordinary to be observed among our daily life, cold and dry air will have lesser vapour of water than the air that is hotter, that is why it happens more in the room where air-conditioning is there and space is confined. For instance, metal products have a higher chance to be static shock due to the nature of the material properties. Antistatic floor supplier Malaysia will usually aim to solve all these related factors after comprehensive studies of those objects in the room. Static electricity can be as simple as from rubbing balloons to the neck since rubber attracts more electrons than other materials such as animal fur. Some materials can be used if wish to achieve anti-static, such as spray coating that contain conducting plastic (also known as polymer) and deionized solvents (alcohol and water). This can work because it allows minimum moisture to be retained within the sprayed object and subsequently discourages the static to build up since it is now more electric-conductive. Antistatic floor supplier in Malaysia does also advise to use vinyl floor as a lesser static electricity generating floor material. Antistatic can be static dissipative too, in addition to insulating materials in playing another role for such function.
Where to Get an Anti Static Floor System Supplier and Contractor in Malaysia
Aathaworld Sdn Bhd provides anti static room and floor system design, its related equipment and building works that include many sectors and manufacturing factories. Aathaworld’s team of engineers, consulting designer and installation manpower can ensure that we can design and build the anti static room required by you. Industries or floors that require anti static are including optical lens, surgical implant production, lasers, munitions manufacturing, micromechanism, military, pyrotechnics, biotechnology, medical center, research lab, server room, technology operation, food and beverage, photographic film, pharmaceutical. As a anti static system contractor in Malaysia, we are able to offer floor consultation, raised flooring, floor refurbishment, room renovation, cleanroom, flooring upgrade of multiple grade of anti static systems requirement in KL Kuala Lumpur, Selangor, Klang Valley, JB Johor Bahru, Penang, Malacca (Melaka), Seremban Negeri Sembilan, Perak, Pahang, Kuantan, Kelantan, Terengganu, Perlis, Alor Setar Kedah, as well as Sabah and Sarawak for East Malaysia. Can also check with us on antistatic requirements for Southeast Asia (SEA) countries such as Singapore, Myanmar (Burma), Cambodia, Vietnam, Laos, Thailand, Indonesia, Philippines, Brunei, Bangladesh as well as China, Taiwan, Hong Kong, Australia and New Zealand. Enquire us for your anti static flooring system supplier and installer in Malaysia today at info@aathaworld.com or call (WhatsApp) to +(60)11-7001 1003 (Monday to Friday) or +(60)11-1188 1003 (Saturday, Sunday & Public Holiday).
Photo credit: impactfloors, floortech, protexion, ferfa, impactfloors, preferredglobal
Comments